Differences

This shows you the differences between two versions of the page.

--- en:ost:telescope:kuppel [2016/10/22 02:22] – [Problems and their solution] rhainich
+++ en:ost:telescope:kuppel [2024/02/20 08:55] (current) – [Inside the dome] rhainich
@@ Line 1: / Line 1: @@
 ====== The Dome ======
+[{{ en:ost:telescope:dome_en_new.png?400|Top view of the dome}}]
-[{{ :ost:kuppel.png?400|Outline of the dome}}]
 ===== Access to roof and dome =====
 **Important**
-  * The door to the roof can be opened with the appropriate key.
+  * The door to the roof can only be opened with the appropriate key.
-  * The door must be closed again because the shutter of the dome could collide with it as the dome rotates. /* Horizontklappe ist.. shutter?*/
+  * The door has to be closed when the telescope is switched on, because the hatch of the dome could collide with it as the dome rotates.
   * Usually the door of the dome itself is locked, too.
-  * The door opens easier if it's slightly pushed close during the unlocking.
+  * The door opens easier if it's slightly pushed during the unlocking.
   * The doorway is lower than the average person's height -- pay attention to your head. :-)
 ===== Inside the dome =====
+[{{ :ost:telescope:steuerkasten.jpg?150|Control box with the emergency button}}]
 **First steps:**
-[{{ :ost:telescope:steuerkasten.jpg?150|Control box with emergency button}}]
    * Just left to the door you can find the light switch (number 2 in the sketch).
-   * The left button is for white light, the right one is for red light.
+   * The left button is for the white light, the right one is for the red light.
-   * At the wall, next to the light switches there's a small box (number 3 in the sketch). It contains
-       * the remote control of the dome,
+**Dome control:**
-       * the sensor that receives the signal of the remote (see Figure)
-       * the emergency button (the red button) that disconnects the power supply of the dome
+At the wall, next to the light switches there's a grey dome control box (left figure & number 3 in the sketch). It contains
+       * the hand control of the dome (see lower right figure),
+       * the sensor that receives the signals from the remote control (the black thing in the middle of the control box figure), and
+       * the emergency button (the red button) that offers the possibility to disconnects the dome from the power supply in case of an emergency.
+The dome has an emergency closing function that automatically closes the dome in case of a power failure. This function is provided by the blue box to the right of the dome control box (number 4 in the sketch). This box has a power switch, if accidentally operated the dome will close automatically and will not respond to any further commands until the switch is operated again. Directly underneath in the black box is the battery, which supplies the power needed for the emergency closure.
+[{{ :ost:telescope:fernbedienung.jpg?150|Remote control for the dome}}]
+[{{:ost:telescope:oms.jpg?180 | Observatory Management System (OMS)}}]
+\\
+\\
+**Observatory Management System (OMS):**
+The Observatory Management System (OMS) is the large metallic box (number 5 in the sketch) right above the left desk in the dome. It is the main interface regarding the operation of the observatory. All components of the observatory are connected to the OMS and can be controlled from here. The central component of the OMS is an internal Windows 10 computer, which provides all necessary software and which can be accessed from any other computer. It allows the remote operation of the whole observatory. A detailed description of the OMS and its operation is documented ... .
+\\
+\\
+**Additional computer hardware:**
+A laptop can be found on the desks at the left wall of the dome (left number 7 in the sketch). It can be connected to the OMS and used to operate the OMS. The laptop runs MS Windows 10 along with the software necessary for the operation of the instruments, in case the OMS should not be used.
-**Computer setup:**
+Of course, the observatory has Internet access and the university wireless LAN is also available on the roof, so that additional information can be obtained from online databases such as [ http://simbad.u-strasbg.fr/simbad/|Simbad]] during observation.
-[{{ :ost:telescope:fernbedienung.jpg?136|Dome control remote control}}]
-At the left wall of the dome find a table (number 5 in the sketch) with the laptop on it. This computer can connect with the telescope and runs MS Windows 7 along with the required software to use the telescope. It also has an internet connection to find information on objects during the observation, e.g. in [[ http://simbad.u-strasbg.fr/simbad/|Simbad]] or to get other information.
 **Miscellaneous:**
-The dome inventory has the following items, too:
+Furthermore, the dome inventory includes the following items:
-    * a small treadle;
+    * two small steps
-    * a movable tread with platform (number 8);
+    * a movable ladder with platform (number 10)
-    * a roll container (number 6), including
+    * a movable storage container (number 8), including:
-          * equipment for the telescope,
+          * equipment for the telescope
-          * manuals,
+          * eyepieces
-          * tools.
+          * manuals
+          * tools
-Each observation (night) must be registered in the log book (either the real book or in the Wiki: [[en:ost:telescope:logbuch|Wiki log book]]). This is especially important if changes at the equipment/mounting/telescope were performed. The roll container can also be used to place a laptop ontop to easily roll it though the dome. However, always ensure all parts of the equipment are standing securely.
+Each observation (night) must be registered in the [[en:ost:telescope:logbuch|Wiki log book]]. This is particularly important if adjustments have been made to the equipment/mount/telescope.