Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
en:ost:telescope:c8_bedienung [2018/01/24 14:44] – rhainich | en:ost:telescope:c8_bedienung [2018/01/26 00:03] – rhainich | ||
---|---|---|---|
Line 3: | Line 3: | ||
===== C8 (Under construction) ===== | ===== C8 (Under construction) ===== | ||
- | The Celestron 8 (C8) is our smallest telescope not accounting for binoculars or finderscopes. | + | The Celestron 8 (C8) is our smallest telescope not accounting for binoculars or finderscopes. |
=== Setup === | === Setup === | ||
Line 14: | Line 14: | ||
^ 2 | The tripod is the backbone of the telescope. | ^ 2 | The tripod is the backbone of the telescope. | ||
^ 3 | This disk is used to stabilize the legs of the tripod from the inside. The rod that punctures this disk will be screwed (with the side showing the thread) from below into the basis of the tripod. This needs to be done until the thread is completely visible on the other side. The rod should now be vertically slidable. | ^ 3 | This disk is used to stabilize the legs of the tripod from the inside. The rod that punctures this disk will be screwed (with the side showing the thread) from below into the basis of the tripod. This needs to be done until the thread is completely visible on the other side. The rod should now be vertically slidable. | ||
- | ^ 4 | Now the mount can be put on the tripod basis. One has to take care that little chromed pin needs to be placed | + | ^ 4 | Now the mount can be put on the tripod basis. One has to take care that little chromed pin from the basis of the tripod |
- | ^ 5 | Anbringung der Gegenwichtsstange und der Gegengewichte | + | ^ 5 | In the next step the counterweight bar and the counterweights needs to attached to the back-end of the mount. First the counterweight bar needs to thread into the opening of the declination axis. Afterwards the screw at the end of the counterweight bar can be removed and the counterweight can be place and fixated on the counterweight bar. Subsequently, |
- | ^ 6 | Anbringung des Tubus | {{ost: | + | ^ 6 | In the next step the tube needs to be attached to the mount. The tube is equipped with a so-called dove tail (the orange thing) that allows a quick and easy attachment of the tube to the mount. Simply, insert the dovetail into the clamp of the mount and tighten the screw of the clamp. |
- | ^ 6.5 | Achsen auswuchten | + | ^ 7 | Afterwards the hand terminal and the power supply can be connected to the telescope. Both can be simply plugged into the labeled ports of the mount. For the hand terminal the corresponding holder should be attached to the tripod first, so that it can be safely stored. |
- | ^ 7 | + | ^ 10 | Subsequently, |
- | ^ 9 | + | ^ 11 |
- | ^ 10 | + | ^ 6.5 |
- | ^ 11 | Gegebenfalls Sonnefilter anbringen | + | ^ 9 |
^ 12 | Alignment ausfuehren, Genau wie am C11, [[en: | ^ 12 | Alignment ausfuehren, Genau wie am C11, [[en: | ||
^ 11 | Fertig | ^ 11 | Fertig | ||
| | ||