Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
| en:ost:telescope:c8_bedienung [2018/01/24 14:44] – rhainich | en:ost:telescope:c8_bedienung [2018/01/25 23:26] – rhainich | ||
|---|---|---|---|
| Line 14: | Line 14: | ||
| ^ 2 | The tripod is the backbone of the telescope. | ^ 2 | The tripod is the backbone of the telescope. | ||
| ^ 3 | This disk is used to stabilize the legs of the tripod from the inside. The rod that punctures this disk will be screwed (with the side showing the thread) from below into the basis of the tripod. This needs to be done until the thread is completely visible on the other side. The rod should now be vertically slidable. | ^ 3 | This disk is used to stabilize the legs of the tripod from the inside. The rod that punctures this disk will be screwed (with the side showing the thread) from below into the basis of the tripod. This needs to be done until the thread is completely visible on the other side. The rod should now be vertically slidable. | ||
| - | ^ 4 | Now the mount can be put on the tripod basis. One has to take care that little chromed pin needs to be placed | + | ^ 4 | Now the mount can be put on the tripod basis. One has to take care that little chromed pin from the basis of the tripod |
| - | ^ 5 | Anbringung der Gegenwichtsstange und der Gegengewichte | + | ^ 5 | In the next step the counterweight bar and the counterweights needs to attached to the back-end of the mount. First the counterweight bar needs to screwed into the back-end of the declination axis. Afterwards the screw at the end of the counterweight bar can be removed and the counterweight can be place and fixated on the counterweight bar. Subsequently, |
| - | ^ 6 | Anbringung des Tubus | {{ost: | + | ^ 6 | In the next step the tube needs to be attached to the mount. The tube is equipped with a so-called dove tail (the orange thing) that allows a quick and easy attachment of the tube to the mount. Simply, insert the dovetail into the clamp of the mount and tighten the screw of the clamp. |
| - | ^ 6.5 | Achsen auswuchten | + | ^ 6.5 | Before using the telescope you have to tare the rotation axes. First lose the clip fixing the right-ascension axis, until you can freely move the telescope around this axis. Now adjust the position of the counterweight such that there is no movement along this axis anymore. Tighten the clip again and repeat this procedure for the declination axis. As there are no counterweights for this axis, one has to shift the tube along the clamp to tare the declination axis. |
| ^ 7 | Teleskopsteuerung anschliessen, | ^ 7 | Teleskopsteuerung anschliessen, | ||
| ^ 9 | Achsen ausrichten | ^ 9 | Achsen ausrichten | ||