Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revisionBoth sides next revision | ||
| en:ost:telescope:c8_bedienung [2018/01/24 14:44] – rhainich | en:ost:telescope:c8_bedienung [2018/01/24 14:57] – rhainich | ||
|---|---|---|---|
| Line 14: | Line 14: | ||
| ^ 2 | The tripod is the backbone of the telescope. | ^ 2 | The tripod is the backbone of the telescope. | ||
| ^ 3 | This disk is used to stabilize the legs of the tripod from the inside. The rod that punctures this disk will be screwed (with the side showing the thread) from below into the basis of the tripod. This needs to be done until the thread is completely visible on the other side. The rod should now be vertically slidable. | ^ 3 | This disk is used to stabilize the legs of the tripod from the inside. The rod that punctures this disk will be screwed (with the side showing the thread) from below into the basis of the tripod. This needs to be done until the thread is completely visible on the other side. The rod should now be vertically slidable. | ||
| - | ^ 4 | Now the mount can be put on the tripod basis. One has to take care that little chromed pin needs to be placed | + | ^ 4 | Now the mount can be put on the tripod basis. One has to take care that little chromed pin from the basis of the tripod |
| - | ^ 5 | Anbringung der Gegenwichtsstange und der Gegengewichte | + | ^ 5 | In the next step the counterweight bar and the counterweights needs to attached to the back-end of the mount. |
| ^ 6 | Anbringung des Tubus | ^ 6 | Anbringung des Tubus | ||
| ^ 6.5 | Achsen auswuchten | ^ 6.5 | Achsen auswuchten | ||